| From | Message |
Mac
Dodge Dakota
JOIN HERE
8/05/2004
12:10:08
|
 Subject: IAT Sensor
IP: Logged
Message:
I got 5.9 that dosen't have a lot of get up and go. I bought a mod that goes on the IAT sensor to fool the computer that the air is colder than it really is. Here is the problem. I can't find it. Any body know where the IAT sensor is for a 2000 dodge dakota 5.9
|
Joey
Dodge Dakota
JOIN HERE
8/05/2004
17:07:38
|  RE: IAT Sensor
IP: Logged
Message:
left side of intake manifold towards the top and on the #2 runner. screws into the manifold
|
Baddeye
Dodge Dakota
JOIN HERE
8/05/2004
21:39:51
| RE: IAT Sensor
IP: Logged
Message:
How much did you pay for the $.25 resistor? You got robbed either way. Sorry..
IMHO, all that "mod" is going to do is make your truck run too rich and get worse gas mileage than it already does.. unless you really need more fuel (ie: have the mods to do it)
Might as well do the IAT relocation mod..same result.
I ran my stock(at the time)03 R/T on a dyno awhile ago and it was stupid rich after about 3200rpm, then it fell off the chart just after 4500. I'm hoping the mods I've done (tb/fipk mainly) will set that straight, but we'll see on the next dyno run.
http://home.surewest.net/jweltch/dyno.jpg
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
