| From | Message |
kc8lbn
GenII
 
10/12/2002
09:35:09
|
 Subject: Where to install aftermarket temp guage
IP: Logged
Message:
95 5.2 4x4, I want to retain all factory guages but I also want my aftermarket guage hooked up, Am I gonna have to use one of the block drains for the sender or is there a better place??
Thanks for your time and you help?
|
kc8lbn
GenII
10/12/2002
10:21:36
| RE: Where to install aftermarket temp guage
IP: Logged
Message:
Water temp that is...
|
street guy
Dodge Dakota
JOIN HERE
10/13/2002
12:20:06
| RE: Where to install aftermarket temp guage
IP: Logged
Message:
on older engines, most of them have a core plug in the intake manifold that was tapped out to 3/8 taper pipe tap. It is usually near the thermostat housing/outlet. Usually, there was water flowing through it directly from the engine block, and I would remove the pipe plug from it and install the sender into the pipe-tapped hole. Lotd of people do not realize that intake manifolds have coolant water flowing through them.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
