| From | Message |
David Reid
Dodge Dakota
JOIN HERE
3/01/2010
15:49:50
|
 Subject: 1995 Dakota 5.2 PCM
IP: Logged
Message:
Hello, I posted about my truck in earlier forums because i have a problem with the truck running rough. I recently ran the codes and one came up as (PCM failure no spi communications) along with a few low votage sensor codes. I am going to replace the pcm but before I do I was wondering if there are any second opinions to what this means. Thanks
|
yepp
Dodge Dakota
JOIN HERE
3/01/2010
20:55:24
|  RE: 1995 Dakota 5.2 PCM
IP: Logged
Message:
hey listen
go under hood
inner side drivers fender well
remove black fuse/relay box
behind it untape wire harness
6 to 8 inches back
locate 3 wires splice together (red and white)
cut the splice out and re-do it
put everything back
and see what happens
|
David Reid
Dodge Dakota
JOIN HERE
3/01/2010
21:51:42
| RE: 1995 Dakota 5.2 PCM
IP: Logged
Message:
I already re-did the splice and it didnt change anything.
|
David Reid
Dodge Dakota
JOIN HERE
3/02/2010
12:01:01
| RE: 1995 Dakota 5.2 PCM
IP: Logged
Message:
When I buy a new or refurbished pcm, does it have to be programmed or is it just a plug and play?
|
daddio
Dodge Dakota
JOIN HERE
3/02/2010
12:30:53
| RE: 1995 Dakota 5.2 PCM
IP: Logged
Message:
Should be plug and play but, I've heard that if there is a factory alarm involved, it will cause problems. Just try to get one from a vehicle with the same configuration and options as yours.
|
David Reid
Dodge Dakota
JOIN HERE
3/02/2010
20:53:36
| RE: 1995 Dakota 5.2 PCM
IP: Logged
Message:
That should be ok cause I took out the aftermarket alarm it had on it.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
