| From | Message |
JerryM
Dodge Dakota
JOIN HERE
9/15/2007
13:19:13
|
 Subject: Ball joint question?
IP: Logged
Message:
I had my ball joints replaced by the Dodge dealership in 2005. It did not cost me anything, and was part of that recall by Dodge.
Today I was looking at the new joints, and there does not appear to be any grease fittings. Does anyone know if these new joints require lubrication?
Thanks!
|
OBIO3
Dodge Dakota
JOIN HERE
9/15/2007
16:38:47
| RE: Ball joint question?
IP: Logged
Message:
DEALER BALL JOINTS HAVE NO ZERKS. MOST AFTER MARKET ONES DO.
|
.boB
Dodge Dakota
JOIN HERE
9/16/2007
13:36:45
| RE: Ball joint question?
IP: Logged
Message:
Factory ball joints are sealed, and do not need periodic greasing like aftermarket ones. Most cars and trucks built in the last few years are the same way.
Some of us old guys think that's a bad thing. Some of the new guys think it's a good thing. You decide.
|
JerryM
Dodge Dakota
JOIN HERE
9/16/2007
14:46:01
| RE: Ball joint question?
IP: Logged
Message:
Interesting bob,
there is a rubber seal around the joint, does not feel like there is any grease inside. maybe just there to protect the joint from dirt, etc
|
.boB
Dodge Dakota
JOIN HERE
9/16/2007
19:26:10
| RE: Ball joint question?
IP: Logged
Message:
yes, the rubber seal is there to keep out dirt and moisture. Also, to keep in the grease. You wouldn't be able to feel the grease unless it's too hard to work anymore.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
