| From | Message |
JD Denny
Dodge Dakota
JOIN HERE
8/13/2004
15:48:47
|
 Subject: 92 3.9 Will Not Start
IP: Logged
Message:
My Dak is giving me problems. It started out like this: I would get in crank it and it would start, then immeidiatly die and I would crank it again and it would start. It did that twice. Then it went to starting sometimes when I pumped the gas. I could get it to start when i pumped the gas right when I turned the ignition. I got new spark plugs, spark plug wires, battery, and distibutor cap & rotor. It still will not start. I think I may have connected the wires to the dist. cap in the wrong order. please any help would be greatly apprieciated. Thank You
|
Ross
Dodge Dakota
JOIN HERE
8/13/2004
16:02:37
|  RE: 92 3.9 Will Not Start
IP: Logged
Message:
The firing order should be stamped on the intake if it is like mine. I had a similar problem. It was my IAC motor caused by a faulty computer. try to clean your IAC and the prot it goes into.
|
Dan M
Dodge Dakota
JOIN HERE
8/13/2004
17:19:53
| RE: 92 3.9 Will Not Start
IP: Logged
Message:
the haynes book has the correct order, also, you can register that autozone.com and it should be there too, i have a '95 club cab 4x4 with 3.9 and mine is listed.
|
JD Denny
Dodge Dakota
JOIN HERE
8/14/2004
11:55:57
| RE: 92 3.9 Will Not Start
IP: Logged
Message:
Sorry but Im not sure what the IAC is. If you could tell me where it is located I would greatly apprieciate it.
|
91Dakota
Dodge Dakota
JOIN HERE
8/15/2004
04:01:10
| RE: 92 3.9 Will Not Start
IP: Logged
Message:
Here ya go. Cleaning procedure.
http://www.speedtweaks.ca/tipsandtricks#CleanIAC
|
Eric N.
Dodge Dakota
JOIN HERE
8/15/2004
10:55:59
| RE: 92 3.9 Will Not Start
IP: Logged
Message:
IAC - Idle Air Controler. It's an electric motor that controls a plunger, which in turn controls the airflow while the throttle is closed.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
