| From | Message |
Jim
Dodge Dakota
JOIN HERE
2/20/2002
16:27:46
|
 Subject: V8 TB prep for V6 install
IP: Logged
Message:
I just acquired a V8 TB from a 5.2L motor.
I will be installing it on a 2000 3.9L w/5 speed, Intense cold air intake, series 50 full flow muffler, relocated IAT and Jet chip.
I have access to a milling machine and I know how to use it! So what should I do to prep the TB? I am aiming for low and mid range power for pulling.
Thanx
Jim
|
bernd
*GenIII*
2/21/2002
00:34:35
| RE: V8 TB prep for V6 install
IP: Logged
Message:
Just clean up the top, remove the airhorns (radius the bore entry at a 45 degree angle as well), and set the TPS at .7v. That's it.
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
bernd
*GenIII*
2/21/2002
00:35:13
| RE: V8 TB prep for V6 install
IP: Logged
Message:
Oops...almost forgot.
Don't forget to either change the linkage or change the throttle cable. The V6's use a ball-stud and the V8's use a disc.
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
