| From | Message |
Trail Dakota
Dodge Dakota
JOIN HERE
4/13/2004
13:50:17
|
 Subject: ? for Larry or others
IP: Logged
Message:
well larry my truck is starting to come together
i have a 1999 club cab 4x4 3.9 auto with 3.92 gears. I just put on a K&N Flip2K intake on it and had my local muffler shop put on a flowmaster 50 2.5 in and dual out 2 with 3 tips. it looks and sounds nice. well the qestion that i have is that i wanted 2.25 pipe out but they said it wouldn't and that B.S. Now i when under the truck and looked at the job they did and it not bad except in one spot in the bend that turns the pipe out for the tail pipe tip. its got crunched up a little to much i think it could be resticting flow. so sould i take it bake have them fix it or will it be okay?
I also changed my plugs yester day to 3923 single platnums and gap them to .04 to stock specs because my gap tool didn't go any bigger except to .05. but i was woundering when i change my plug wires and cap and rotor should i gap them out more. when i checked the stock plugs they where gaped over .05 so i don't know what to do . any help would be greatly helpful i know theres a few qestions here
thanks Trail Dakota
|
huh?
Dodge Dakota
JOIN HERE
4/13/2004
14:25:08
| RE: ? for Larry or others
IP: Logged
Message:
How old are you Trail? I could barely read get through your post. I had to sit here and think what you were trying to say....
|
trail Dakota
Dodge Dakota
JOIN HERE
4/13/2004
14:30:48
| RE: ? for Larry or others
IP: Logged
Message:
I see what you mean i sould really proof read before i post hee
|
dak-jak
Dodge Dakota
JOIN HERE
4/14/2004
11:27:56
|  RE: ? for Larry or others
IP: Logged
Message:
Get the Good cap and rotor ( brass contacts )
and yes , gap out.
Exhaust should be OK as long as not Too badly
scrunched..
|
J and J Auto
GenII
 
4/14/2004
21:51:49
| RE: ? for Larry or others
IP: Logged
Message:
Did I not answer this on another post
Yes AP Autolight plugs gap .005 over stock
if .040 gap .045
Unless the pipes are mandrel bent there will
always be a little ripple effect on the pipes
They have now come up with a hydronic bending
system using water presure in pipes while bending
to increase flow even better than a mandrel bend
On you aplication I would not worrie to much about
it.
Napa MO26 and MO28 cap and rotor solid brass
incerts around $15
Taylor 8mm or
MSD 8.5mm
both good wires around $60
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
