| From | Message |
six pack
Dodge Dakota
JOIN HERE
3/06/2004
09:31:38
|
 Subject: injectors
IP: Logged
Message:
got a ohc ford police motor at work blown chain broken rockers BUT injectors are good 4 hole for 4.6 plan to install on dodge and see what happens anybody tried this experiment
|
blueballs
Dodge Dakota
JOIN HERE
3/06/2004
11:10:12
|  RE: injectors
IP: Logged
Message:
What psi are they? Any more than 21 lil to much. Unless s/c or giggle gas.
|
J and J Auto
GenII
3/06/2004
14:37:10
| RE: injectors
IP: Logged
Message:
depending on year of truck
92 to 99 19#
00 and up 21#
Yes depending on year the 4.6 did have the orange
19# FMS Bosch injectors and will fit right in the
dodge motors
You can get a new set of o rings at auto zone for
around $5 just get for 4.6 mustang they are the
same but not listed for dodge.
Also use a little oil on the rings during instal
this makes it easier and asures a good seal
I am running the FMS 4 hole on my 92 and 95 3.9
as many dodge owners are and they work great
compaired to the 1 hole wonders the factory uses
Larry
J&J Auto
|
six pack
Dodge Dakota
JOIN HERE
3/06/2004
17:47:55
| RE: injectors
IP: Logged
Message:
thanks for feedback j&j the ones i have my eye on are orange they also are found on the crown vics in our fleet in grey and black the dealers parts dep was no help when i tried to identify them truck is a 99
|
J and J Auto
GenII
3/07/2004
15:03:59
| RE: injectors
IP: Logged
Message:
Yes the orange are the FMS Bosch 19# and will fit
right in your 3.9
on some trucks it is nessisary to remove the
throttle body because the fuel rail will not lift
high enough on the pass side.
You can also do 1 side at a time the fuel line
crosing over the intake is flexible.
Just leave the clips on, wiggle and pull out of
intake but be sure to blow the intake off so no
dirt drops in.
flip the rail over and pull the clips and
injectors 1 at a time this way you can also
compair the height because onn the FMS injectors
you can have the clips in 2 diff slots.
Stick them back in the holes and push down ince
you tighten the rail back down it will fully
seat the injectors, plug them in and your all set
They are a nice change over stock smother over
the entire rpm range
being matched within 2% over factory 15% makes
the V6 a lot crisper and cleaner running, less
bog and rich flat spots
Larry
J&J Auto
|
Alan
Dodge Dakota
JOIN HERE
3/08/2004
01:11:31
|  RE: injectors
IP: Logged
Message:
Just picked up a set of 6 from auto wreckers,was glad to see some info was posted as I plan to install them this week, hopefully Monday. One question, the injectors I got have a different stock number (last 3 numbers) on the side than the ones that I saw on fiveomotorsports for Dodge applications, mine are orange,19#,is this an issue or not?
Thanks, Alan
98 CC auto V6 w/mods
|
Deep Purple
*GenIII*
3/08/2004
13:10:25
| RE: injectors
IP: Logged
Message:
The orange ones may be the FMS 19lb Ford injectors part #FOTE-D5B. I think they are the retail ones like Summit sells. I've got a spare set of them. Bruce at Five0MotorSports could tell you more. Good luck.
|
Alan
Dodge Dakota
JOIN HERE
3/09/2004
01:36:46
| RE: injectors
IP: Logged
Message:
Installed injectors today, truck runs great, does anyone know if I should re-set the PCM or not?
Thanks, Alan
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
