| From | Message |
regcabdak
Dodge Dakota
JOIN HERE
2/29/2004
06:00:10
|
 Subject: 3 angle valve job
IP: Logged
Message:
I was reading a magazine, and in an artical they talked about how a 3 angle valve job would increase the low end power as it flows more air.
Has anyone done this to thier engine? And could you tell the difference in power after doing the 3 angle?
Thanks
Tyler
|
J and J Auto
GenII
 
2/29/2004
10:10:40
|  RE: 3 angle valve job
IP: Logged
Message:
If you having a valve job done yes 3 angle but
don't take your truck apart there is no gain
there.
Maybe just run a little smother, a lot if you do
have bad valves and need to have it done.
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
