| From | Message |
J and J Auto
GenII
 
2/28/2004
08:17:37
|
 Subject: Tazzy harland sharp rockers
IP: Logged
Message:
Tell me about these rockers I am not familiar with
them
On there website they show 2 sets for the V6 adjustable
and none adjustable which did you use
How are they holding center, with guide plates or guided
roller tips
They are more than a hundred dollars cheaper and
customers would like that most cant afford over $400
installed but $300 they would probably go for
Thanks
Larry
J&J Auto
|
tazzy
GenIII
2/28/2004
09:14:28
| RE: Tazzy harland sharp rockers
IP: Logged
Message:
I'm using the non-adjustable..
There installed in pairs.2 rockers are connected by a small center shaft. which keeps each aligned.
Took approx 1 hour to do.Thats with dropping a push rod into the galley..
Just remove old rockers and install new..they sit on a spacer..
|
Wadak
Dodge Dakota
JOIN HERE
2/28/2004
11:04:49
| RE: Tazzy Harland sharp rockers
IP: Logged
Message:
Tazzy, Are these Aluminum or Steel? Just Curios
|
tazzy
GenIII
2/28/2004
11:21:07
| RE: Tazzy harland sharp rockers
IP: Logged
Message:
Harland Sharp Rockers
|
JFH
Dodge Dakota
JOIN HERE
2/28/2004
11:49:39
| RE: Tazzy harland sharp rockers
IP: Logged
Message:
Did you get the 1.7'S? and if so, Did you need to modify the valve covers? According to the site it is not nessicary.
|
tazzy
GenIII
2/28/2004
11:58:44
| RE: Tazzy harland sharp rockers
IP: Logged
Message:
Got the 1.7's did'nt mod the covers..
I got them from South East R/T
|
billy bob
Dodge Dakota
JOIN HERE
2/29/2004
01:35:46
| RE: Tazzy harland sharp rockers
IP: Logged
Message:
hey larry they are aluminum
good luck selling them as se rt sells them at cost or cheaper
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
