| From | Message |
TimG
Dodge Dakota
JOIN HERE
11/04/2003
16:19:45
|
 Subject: Cylinder head C.C.s ?
IP: Logged
Message:
Anybody know what the stock cylinder head c.c.s are on a 1997 3.9 Dak. ??
Is it 58cc, 62cc, 70cc, or 64cc ??
|
J and J Auto
GenII
11/04/2003
20:05:36
| RE: Cylinder head C.C.s ?
IP: Logged
Message:
You know I cant remember would have to look it up
but 58 seams to ring a bell
Larry
J&J Auto
|
TimG
Dodge Dakota
JOIN HERE
11/05/2003
10:46:06
| RE: Cylinder head C.C.s ?
IP: Logged
Message:
Thanks Larry, I was looking at piston sets @ Hughes engines.com and was trying to figure out what compresion ratio I would end up with.
|
J and J Auto
GenII
11/05/2003
11:25:41
| RE: Cylinder head C.C.s ?
IP: Logged
Message:
Ross, Keith Black will make you anything you want
my 10 to 1 KB's were just under $300 with shipping
Just call or email Hughes they can tell you
exactly what you would have
I could not tell you how much dif the higher comp
made because they went in with the stroker crank
I would say both made 35 40 HP but the longer
stroke sure brought in some low end torque, made
the truck a lot more fun to drive
The stock pcm would lean out around 3000 rpm
the ASE was better, now figure this the 92 mopar
performance pcm did not have the lean out prob
at all.
They must have some good fuel curves
I was running an Apexi fuel control but don't
now and the Apexi sold the day I took it off
the local off road racing team bought it.
These guys have a blown V6 straight line mud
drag truck running 90% nitro meth pulling over
400 HP man I went for a ride in that truck its
no less than pure insanity, I am not usualy
botherd by speed but on a dirt track hitting
120 in the straights scared the crap out of me
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
