| From | Message |
Green GenII
Dodge Dakota
JOIN HERE
5/05/2003
14:47:20
|
 Subject: Gen II Motor Mounts
IP: Logged
Message:
Alright I am eating these things up. I have been using Anchor brand motormounts and they always fall apart at the bonding points. Does anyone know of a performance motor mount for a 3.9 or maybe just a different brand?
|
jkw
Dodge Dakota
JOIN HERE
5/05/2003
18:44:17
|  RE: Gen II Motor Mounts
IP: Logged
Message:
I have the same problem with my motor mounts. I'm about to replace my 2nd set on my 94 Dak. I went and bought some from Napa, hopefully they will hold up better.
|
FazDak
GenII
5/05/2003
19:26:22
| RE: Gen II Motor Mounts
IP: Logged
Message:
Not to say this is your problem but try putting in a new good quality trans mount at the same time.
I have seen the problem go hand in hand.
|
Dan
Dodge Dakota
JOIN HERE
5/22/2003
23:37:16
|  RE: Gen II Motor Mounts
IP: Logged
Message:
I work at napa iv gone through 3 sets of motor mounts..I think its more that they arnt made to handle the motor or torque.. iv also been through a standard tranny and 4 rear ends.. it used to have awsome power.. but sionce iv rebuilt the motor it just dont seem to go like it used to.. i used to be able to bake 2nd gear donughts all day long.. im gonna try ther tps mod and check the timing again .. any other ideas?
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
