19:11:07 - 12/10/2018
Subject: Replacing Oxygen Sensor|
I need to replace the upstream driver-side oxygen
sensor on my 2002 3.9L. I can only partially see
the connector and there appears to be no way to
physically reach it to dis-connect (i.e., it is in
the area between the transmission and the cab
floor.) Does anyone know a way to access the
connector? I was thinking alternatively that I
could cut the wires at the sensor and splice to the
new connector. Has anyone done it this way?
| RE: Replacing Oxygen Sensor|
No, you need to pull apart that connector.
If necessary, just pull on the cable to the sensor to bring the connection to where you can access it..
| || P 1|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages