Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
05:41:49 - 12/10/2024

V6 Dakotas
FromMessage
urban
Dodge Dakota
JOIN HERE
 Email

8/16/2010
22:44:30

Subject: Loose Pulley - Water Pump - Fan Clutch
IP: Logged

Message:
Hello there,

I have a 2000 3.9L V6 that I was driving home the other day when I suddenly noticed a severe squeal and scraping type sound coming from under the hood. When I made it home I noticed the serpentine belt had lost a groove and the slice of belt was wrapped around near the fan blades.
I replaced the belt, started it up, and immediately heard the same noises and found the belt had come off slightly near the water pump pulley. I inspected that pulley further and pulled out some more pieces of belt from behind it and then noticed that pulley has a pretty good wobble. The pulley, nut, fan-blade assembly, and fan clutch all wobble together..
I have been advised that I need to replace the fan clutch; I just can't understand how a new fan clutch would 'fix' the loose pulley (that is on the water pump). I still need to devise a way to hold the pulley so I can get the nut loose (I am thinking of trying a rubber strap wrench on the pulley.
I have never had any problems with it overheating, so I am assuming the water pump is fine; however I have read that the water pump and pulley are the same 'part'.
I am just looking for any advice or clarification someone might be able to give me, as I can't seem to find it in black & white by searching.

I appreciate it, thanks alot.




yea
Dodge Dakota
JOIN HERE


8/17/2010
02:07:23

RE: Loose Pulley - Water Pump - Fan Clutch
IP: Logged

Message:
Grab the fan and try to wiggle it back and forth,
Could also be the bearings in the water pump let go.



?
Dodge Dakota
JOIN HERE


8/20/2010
13:00:39

RE: Loose Pulley - Water Pump - Fan Clutch
IP: Logged

Message:
Need new water pump .



urban
Dodge Dakota
JOIN HERE
 Email

8/22/2010
21:12:49

RE: Loose Pulley - Water Pump - Fan Clutch
IP: Logged

Message:
Thanks alot for the replies. I take it then that the bearings are pressed into and basically part of the water pump and not a separate part that I could replace. In other words, I have to replace the entire water pump?
I just want to be sure because replacing bearings is something I can probably do myself once I get the nut behind the fan blade assembly loose, whereas replacing a water pump is probably out of my league because I work alot, don't have a garage and lack most of the tools needed...
Thanks again for any further clarification.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.