| From | Message |
Jay Wingate
Dodge Dakota
JOIN HERE
11/19/2006
12:01:28
|
 Subject: 9 1/4 rear end
IP: Logged
Message:
Will an RT 9 1/4 rear end fit in place of my 8 1/4 rear end without any major modifications? The 8 1/4 is going out and I have a chance to get one from a wrecked RT. Thanks for the responses.
|
Kowalski
GenIII
11/19/2006
12:44:59
| RE: 9 1/4 rear end
IP: Logged
Message:
Can't say without knowing what years you are talking about. For example, a gen 3 rear is wider than a gen 1 or 2.
Lead, follow, or get out of the way
|
Jay Wingate
Dodge Dakota
JOIN HERE
11/19/2006
16:48:18
| RE: 9 1/4 rear end
IP: Logged
Message:
I've got a 98 and the RT is 2000. Thanks for responding.
|
Dakotaian
Dodge Dakota
JOIN HERE
11/20/2006
06:51:05
| RE: 9 1/4 rear end
IP: Logged
Message:
What is wrong with your old rearend?
|
Kowalski
GenIII
11/20/2006
07:22:00
| RE: 9 1/4 rear end
IP: Logged
Message:
Same width - you should be fine.
Lead, follow, or get out of the way
|
97 dak
Dodge Dakota
JOIN HERE
11/21/2006
08:59:01
| RE: 9 1/4 rear end
IP: Logged
Message:
just make sure your gear ratios are the same or you will be really screwed when you put it in 4 wheel
|
Jay Wingate
Dodge Dakota
JOIN HERE
11/22/2006
17:14:47
| RE: 9 1/4 rear end
IP: Logged
Message:
The yoke on the 9 1/4 is a flat flange. Do I need an adaptor to match the driveshaft up or should I change the yoke to the standard yoke like the 8 1/4? Thanks for your response.
|
J and J Auto
GenII
11/23/2006
00:34:05
| RE: 9 1/4 rear end
IP: Logged
Message:
mopar only used 2 sizes ujoints it should be the
same however check the length on the drive shaft
both G3 trucks so the spring pads will be the same
and bolt right in
almost all of the RT's had the 3.92 ratio and the
sure grip posi the 8.25 it was 3.91 if it is a
4x4 you will need to get a 3.91 in the front
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
