| From | Message |
stevedak
Dodge Dakota
JOIN HERE
11/16/2006
16:22:09
|
 Subject: injector issues
IP: Logged
Message:
During normal driving, my dakota started missing. the check engine light came on and I found code 27 set (injector output circuit response). The symptoms where the same as when I had one of the electrical connector come off an injector, it runs rough (the clips securing the connectors are long gone). I checked the electrical connectors and they were all on. With the truck running, I put a screw driver to each injector and herd each one ticking.
I suspect I have a bad injector, does anyone have an idea how to isolate which one??
92 3.9L V6, auto, v8 TB, CPS mod, IAT mod,
|
daddio
Dodge Dakota
JOIN HERE
11/16/2006
16:51:30
| RE: injector issues
IP: Logged
Message:
i guess you could ohm them out. but i don't know the correct values they should have.
|
J and J Auto
GenII
11/17/2006
23:35:38
| RE: injector issues
IP: Logged
Message:
fiveomotorsports.com has the ohms listed on
there site right by the injectors
92 I would just replace them all for under $200
19 pound bosch FMS they have the 4 hole spray
matched closer better atomization
smother idle and overall running motor with
mid and top end gains and better mileage
They come with new o rings ready to install
and bruce gets them out fast
If your trying to save money go to radio schack
get a can of contact cleaner and spray them out
injector and plug it may just be some corosion
try that first
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
