| From | Message |
try_my_6
Dodge Dakota
JOIN HERE
8/27/2006
14:10:40
|
 Subject: power to the ground
IP: Logged
Message:
can anyone tell me what i could do to get more power to the ground? my engine get good throttl response,but it just doesnt make it to the tires. could this be because of the tranny twisting when i get on it? the rubber bushing seems a little soft i can move it with my hand. probably cause when i put headers on it the cat wouldnt bolt up right so i got rid of it, and it had a hook that went into the tranny and makes it sway a lot. my question is can i weld a piece of thin steel to keep the tranny from moving so much under acceleration?
|
Obio3
Dodge Dakota
JOIN HERE
8/27/2006
14:43:46
| RE: power to the ground
IP: Logged
Message:
Unless your rubber mounts have rotted (and I doubt that) Your looking in the wrong place. Also to strap your trany to the fram or crossmember is going to bust something if you really are getting on it hard. Your eliminating needed give plus you well get lots of gear noise. If your engine is performing as good as it can, I see 2 choices. Mod the engine or change the gears in diff.
|
barry
Dodge Dakota
JOIN HERE
8/27/2006
16:24:03
| RE: power to the ground
IP: Logged
Message:
sounds like you need a posi rearend ..........thats what i put in...got it from the junk yard for $250 then i put ladderbars so the rear end wont twist
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
