| From | Message |
bridges
Dodge Dakota
JOIN HERE
4/25/2006
01:37:32
|
 Subject: will not start
IP: Logged
Message:
I have 89 v6 dakota but cannot get this thing running for ^%^%( . I have been looking everywhere.Alternator has been changed it was bad,new battery,coil even went through the harness and redid some of the splices. Yet I still cannot get the voltage I need at Pin 1 on the distributor plug. Even the computer was replaced due to bad resistor. checked grounds but I am stumped!!!
|
J and J Auto
GenII
4/25/2006
02:07:36
|  RE: will not start
IP: Logged
Message:
Now the fun begains trace the wire back and see
where your losing it
posible fuse or ign switch or connection
The last one I ran into was a 94 ram had to undo
the harnass from the o2 trans all the way upto
the back of the motor where they so convenlently
put a splice that went bad
Have Fun LOL!!!
Larry
J&J Auto
|
bridges
Dodge Dakota
JOIN HERE
4/25/2006
20:45:18
| RE: will not start
IP: Logged
Message:
Larry this has been a nightmare project. But thanks for the advice....will keep informed....
|
mack
Dodge Dakota
JOIN HERE
4/28/2006
08:46:24
| RE: will not start
IP: Logged
Message:
Larry i broke down and found another harness but same results...What ever the problem is I am getting code 24 for TPS but that is new the resistance and voltage are good ASD good...but I have given up and looking for a V8 with carb...too much time with this one should have kept my 4 cylinder....
|
Obio3
Dodge Dakota
JOIN HERE
4/29/2006
16:32:58
| RE: will not start
IP: Logged
Message:
unrapping wires is very easy to do . Start at the pin you know is bad. Have a new roll of black taoe in hand . Each foot you unrap, rerap from the pin end. No problems keeping wires rapped as new and when you do find the problem, the job is done. so easy
So many problems .... So little time
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
