| From | Message |
jay
Dodge Dakota
JOIN HERE
4/05/2005
16:03:17
|
 Subject: ground wire for amplifiers
IP: Logged
Message:
would anyone happen to know of a good location to put a 4 gauge ground wire inside the truck.
98 dodge dakota
|
Doug
Dodge Dakota
JOIN HERE
4/05/2005
17:52:31
|  RE: ground wire for amplifiers
IP: Logged
Message:
I have mine bolted/attached to the driver side seat/floor board(right where the seat bolts done), no heating or problems and i have had it this way for about 3 years(2-12in subs with a 750W amp)
|
another mark
Dodge Dakota
JOIN HERE
4/05/2005
19:53:24
| RE: ground wire for amplifiers
IP: Logged
Message:
I'll second that ground point at the seat bolt on the floor for an amp.
4 gauge ?????? Damn, isn't that a bit much?
|
caksustoms
Dodge Dakota
JOIN HERE
4/05/2005
21:07:45
| RE: ground wire for amplifiers
IP: Logged
Message:
clean the metal with a wire wheel and then use two screws to hold the crimp in place one in the hole and one between the hole and crimped end then paint it to seal it. try to go threw double steel and always never have the threads exposed to the underside of the vechile- it will rust{michigan} in about a year. this is the best way i am a 12volt installer
|
93dak4x4
Dodge Dakota
JOIN HERE
4/05/2005
21:15:33
| RE: ground wire for amplifiers
IP: Logged
Message:
i also have mine at the seat bolt.
|
BD
Dodge Dakota
JOIN HERE
4/06/2005
14:31:16
| RE: ground wire for amplifiers
IP: Logged
Message:
Im using the seatbelt bolt
|
jay
Dodge Dakota
JOIN HERE
4/06/2005
16:43:51
| RE: ground wire for amplifiers
IP: Logged
Message:
thanx eveyone. ok, so how would i go about hooking it up ?
i'm not really following the two screws to hold the crimp. have an simpler terms ?
thanx
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
