| From | Message |
Ken
Dodge Dakota
JOIN HERE
9/07/2004
08:20:13
|
 Subject: TB swap & check eng light
IP: Logged
Message:
I recently installed a V8 throttle body and now I have a trouble code of p1494. What does this mean and what could I do to fix it all help would be good thanks in advance. Also if anyone has a link for all the dodge trouble codes. It a 2002 sprt 4x4
|
?
Dodge Dakota
JOIN HERE
9/07/2004
08:36:50
|  RE: TB swap & check eng light
IP: Logged
Message:
http://www.obdii.com/codes.asp
This is one link for codes.
Unfortunately - It won't work for yours ( p1494 )
One place to start is the throttle body.
Are all connections in place securely ?
|
tek
Dodge Dakota
JOIN HERE
9/07/2004
12:45:49
| RE: TB swap & check eng light
IP: Logged
Message:
I would check the sensors on the throttle body, I had problems with mine when I did the swap and it was because of a low voltage from/to the absolute throttle position. Check your sensors, reconnect them all, and then reset the ecu by disconnecting the battery and draining all the power from the truck by turning the key to the on position for at least 30 seconds before removing the key and reconnecting the battery.
|
J and J Auto
GenII
9/07/2004
15:09:54
| RE: TB swap & check eng light
IP: Logged
Message:
Leak Detection Pump Switch or Mechanical Fault (Chrysler, Jeep)
Check all your vac lines and elec connections
something is not right there,
On your 02 you need to have a throttle body from
a 96 or newer V8
Check everything than disconnect the batt and hold
key all the way to start position for 1 min turn
key off and reconnect the batt,
Now start let idle for aprox 1 min shut off, restart run 1 min shut off, now restart and the
new idle will be learned
50 miles short term learn
200 to 300 and it should have a complete learn for
the new body
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
