Forums
Forum Tools
|
 |
17:51:59 - 04/25/2024
Custom Style
| From | Message |
99dakman
Dodge Dakota
JOIN HERE
1/28/2002
21:11:20
|
 Subject: roll bar
IP: Logged
Message:
does anyone know if there is anyone out there who makes a rollbar/light bar for a dakota it seems to be an elusive thing to find anyone with info would be greatly appreciated.
|
2THEXTRM
GenIII
1/28/2002
21:23:47
|  RE: roll bar
IP: Logged
Message:
I have been researching this for over 3 months and I think Smittybilt may have one for us but I still need to verify this. If you find out before me, please post on this thread, maybe we can buy two and save some $$?
Flowmaster stainless cat back, Air Raid CAD and homemade TB connect, Poweraid TB Spacer, Splitfire Plugs
3 inch body and 1.5" block lift, 33x11.50-16's, Superlift Truspeed Recalibrator
Powerslot Rotors, Ceramic Brake Pads
|
ZenDak
Dodge Dakota
JOIN HERE
1/29/2002
12:25:00
| RE: roll bar
IP: Logged
Message:
Ya'll probably already seen it but there is the light/roll bar from Mopar. Single piece that includes the bed rails,,,not too bad. Love it / Hate it look.
Would like to take a moment to brag about my Westin Push/light bar. 1hr. after installation, my little bro goes through front gate, and gaurd stops us cold at about 10MPH. No damage to guard,,need new hangers as it's sitting a bit crooked,,,but no damage to bumper,lights, or guard itself! Need new hood,,,gate flew up and landed on it :(
But I'm getting the cowl hood so... :)
Just happy venting....
Andy
|
Dakota
GenIII
1/30/2002
14:52:19
| RE: roll bar
IP: Logged
Message:
Grizzly makes one to fit the Dakota. There website is down, butif you call a rep, they can send you some info on it. It runs for about 500.00 Its a single/single...and is just higher than the 3rd brake light.
-Dakota
3" Body Lift
Quick D Intake
Dynomax Race Magnum Exhaust
Http://dakota.4mg.com
|
2THEXTRM
GenIII
1/30/2002
19:35:48
| RE: roll bar
IP: Logged
Message:
Thanks Dakota, I'll have to get ahold of them and see what they have. I was actually thinkin a double/single if they make one, like the looks better.
Flowmaster stainless cat back, Air Raid CAD and homemade TB connect, Poweraid TB Spacer, Splitfire Plugs
3 inch body and 1.5" block lift, 33x11.50-16's, Superlift Truspeed Recalibrator
Powerslot Rotors, Ceramic Brake Pads
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
