| From | Message |
Willie
Dodge Dakota
9/18/2001
02:16:42
|
 Subject: Fog Lights
IP: Logged
Message:
I have a 2001 Quad cab dakota. It has the crome bumper with the gray plastic like thing below it. I got some fog lights for those two holes on the bumper. But the instructions tell me to take a working knife to cut the plastic holes out. I am kinda scare about cutting the holes because It will be permanent if i mess up. What is the best way to cut the holes? Will this cut show up when I put in the fog lights.
|
Eddi
Dodge Dakota
9/18/2001
19:35:47
| RE: Fog Lights
IP: Logged
Message:
what I would do is cut the hole just a little smaller then use a dremel do hit the edges a little just my $0.05
|
JP
Dodge Dakota
9/18/2001
22:13:19
| RE: Fog Lights
IP: Logged
Message:
I did this a couple of months ago. I invested $20 in a 4" hole cutter and it looked great. You are right in that if you screw up it is bad news. I would be glad to share the cutter if you are close!
JP, Kent, WA
|
JP
Dodge Dakota
9/18/2001
22:15:04
| RE: Fog Lights
IP: Logged
Message:
I did this a couple of months ago. I invested $20 in a 4" hole cutter and it looked great. You are right in that if you screw up it is bad news. I would be glad to share the cutter if you are close!
JP, Kent, WA
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
