| From | Message |
Your mutha
Dodge Dakota
JOIN HERE
5/04/2003
00:32:34
|
 Subject: Mesh in Front Air Dam
IP: Logged
Message:
How did you guys secure mesh in the air dam below the bumper. I made a custom grill with my own mesh and i want it match below but i can't figure out how to mount it securely. Right now its just held in place with good ole ducktape. I dont wanta drill and i don't want it to permanant unless it has to be. Got any ideas???
|
nitroussteve
DakotaEnthusiast
 
5/04/2003
00:42:16
| RE: Mesh in Front Air Dam
IP: Logged
Message:
there are factory bolts on the back side of the bumper,remove one at a time and utilize them.(add washers to hold mesh)
www.dodgetruckworld.com/nsperformance/
|
DakSport
Dodge Dakota
JOIN HERE
5/05/2003
00:34:16
| RE: Mesh in Front Air Dam
IP: Logged
Message:
use fuel line or any rubber hose that fits really tight into the 3 poles. Then you cable tie it and put some goop(glue) on it and jam it into the poles. Mine held for 8 months no problem until i got an aftermarket insert.
|
justin
Dodge Dakota
JOIN HERE
5/05/2003
23:56:07
| RE: Mesh in Front Air Dam
IP: Logged
Message:
use steelworks stuff from lowes, its sturdier and last longer than all those ideas...i have a few pics at: members.cardomain.com./jfresh but if u need more pics my friend has a few up at memberes.cardomain.com/idol_pimpz hope that helps.
justin
|
conig
Dodge Dakota
JOIN HERE
5/06/2003
17:33:39
| RE: Mesh in Front Air Dam
IP: Logged
Message:
zip ties!!!!!!!!!!!!!!!!!!!
I did it couldn't even really tell they were there unless you looked. I've since upgraded to billet though.
|
DakotaJeff
Dodge Dakota
JOIN HERE
5/06/2003
19:03:00
| RE: Mesh in Front Air Dam
IP: Logged
Message:
LOLOL..mee too conig..
Jeff
http://dangerousobsession.tripod.com/jeff.htm
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
