| From | Message |
Zu71whit
Dodge Dakota
JOIN HERE
11/24/2002
14:42:29
|
 Subject: Wont run after body lift
IP: Logged
Message:
I just finished installing my PA body lift and now my truck wont idle. Itll run if you hold on the gas just slightly but the minute you let off it dies. Ive checked everywhere and cant find anything disconnected. There was a gound strap pulled loose but I replaced that. Any ideas? Please Help.
|
jeff kreman
GenIII
11/24/2002
16:44:34
|  RE: Wont run after body lift
IP: Logged
Message:
Check your throttle body to see if the accelerator cable came off.
Run your fingers over my truck, and I'll run over your fingers with my truck!
|
2THEXTRM
GenIII
11/24/2002
17:42:54
| RE: Wont run after body lift
IP: Logged
Message:
Really sounds you like you could have a pinched vaccuum line, check all the lines you visibly see for any signs of kinking or being pulled off from their connectors. Especially the large one attached to the side of TB.
Flowmaster cat back w/15 inch chrome tip, Volant Intake, Poweraid TB Spacer, Splitfire Plugs, full synthetic fluids
3 inch body/1.5 inch Block Lift, 305 70-16 X-Terrains on AR Terons, Pro Comp ES9000's
Grizzly double/single rollbar with (6) Hella's, Manik Nerfs, Line-X, Hard Work & $$$$$$$$$$
|
chaximus
Dodge Dakota
JOIN HERE
11/26/2002
08:50:50
| RE: Wont run after body lift
IP: Logged
Message:
Yeah, when installing a body lift, you stretch some of the hoses and wires as you go up. I noticed that on my truck and some of the wires are pretty stiff now. So check around and re-read the lift manual to make sure you didn't miss any extensions.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
