| From | Message |
TailG8n
Dodge Dakota
JOIN HERE
11/06/2003
21:48:57
|
 Subject: Gen1 header Question
IP: Logged
Message:
ok im just curious, if i was to buy a set of
headers for a gen2 V8 would they fit my gen 1
v8? cause my 408 is in place but i have no
manifols or headers... hmm, thanks
|
jackinArnd
Dodge Dakota
JOIN HERE
11/06/2003
23:15:58
|  RE: Gen1 header Question
IP: Logged
Message:
nope your screwd dood
|
gen1dak
Dodge Dakota
JOIN HERE
11/07/2003
00:18:18
| RE: Gen1 header Question
IP: Logged
Message:
Which gen1 headers are you talking about? Magnum or pre-Magnum? Magnum manifolds fit nicely, so get headers for the Magnum engine. They follow the same form-factor as the OEM manifolds. Consider yourself unscrewed.
|
01Motorsport
Dodge Dakota
JOIN HERE
11/07/2003
09:24:48
| RE: Gen1 header Question
IP: Logged
Message:
All Gen I's had pre-Magnum engines. Any aftermarket 318 headers up through 1991 should fit. The first GenII with the "aero" nose came out in '91, but with the old-style 318. The Magnum design started in 1992.
|
gen1dak
Dodge Dakota
JOIN HERE
11/07/2003
11:37:55
| RE: Gen1 header Question
IP: Logged
Message:
Yes, I know this. My question was pertaining to the design of the headers in question. The pre-Magnum style follows a more conventional downward, then back style, while Magnums sweep back, then downward.
|
tailg8n
Dodge Dakota
JOIN HERE
11/07/2003
20:11:52
| RE: Gen1 header Question
IP: Logged
Message:
???? if it matters... im pretty sure ANY gen1 or gen2 headers will fit any gen1 or gen2 small block...
but my original question was-
will Magnum V8 headers fit an older pre mag engine in a gen1 dakota... i still dont know if they will or not, help, you all are confusing.
|
gen1dak
Dodge Dakota
JOIN HERE
11/07/2003
20:39:15
| RE: Gen1 header Question
IP: Logged
Message:
Actually, you asked if gen2 headers would fit, which is why I asked Magnum or pre-Magnum. Now, while Mopar may say there are only two generations of Daks, it's generally considered by the consumers that there are three generations. As to your question, which I clearly answered in my first reply in this thread, yes, Magnums fit easily in gen1daks.
|
duh
Dodge Dakota
JOIN HERE
11/11/2003
00:14:07
|  RE: Gen1 header Question
IP: Logged
Message:
duh, that doesnt matter! the exaust mounting flanges are the same for magnum AND pre-mag engines. therefor, yes tailg8n any GenII v8 headers will fit your pre-mag engine in your gen1 dakota. regardless if they are for a mag or not. thanks.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
