| From | Message |
jason
Dodge Dakota
JOIN HERE
6/04/2003
22:37:18
|
 Subject: torque on ball joint to a-arm?
IP: Logged
Message:
I am in the middle of lifting my 97 dakota with a 3" FabTech liftkit. However, FabTech doesn't give any specs for how tight to torque down the four bolts that hold the ball joint to the upper a-arm. What should I use? While we're at it, I replaced the lower a-arms ball joints and can't find any torque settings for how tight to tighten the new one to the a-arms. Thanks for any/all info.
|
pete
Dodge Dakota
JOIN HERE
6/05/2003
00:29:24
| RE: torque on ball joint to a-arm?
IP: Logged
Message:
i just put some good size umph into them...
pete
|
Jeff W
DakotaEnthusiast
6/05/2003
06:34:20
| RE: torque on ball joint to a-arm?
IP: Logged
Message:
...and a little thread lock wouldn't hurt either.
'02 Sport 4.7 auto, Gibson exhaust, homebrew K&N cold air, 275/60 BFG Radial T/A's, Infinity CD w/Pioneer & Infinity spkrs & Kenwood powered sub.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
