| From | Message |
Dread
Dodge Dakota
JOIN HERE
2/04/2003
00:03:21
|
 Subject: tb swap and coil location
IP: Logged
Message:
was wondering if anyone has some simple directions/tips on installing throttle cable for swapping out the v6 tb, for a v8 tb, also, has anyone installed a msd blaster coil, if so, where?? and which wire is positive when u spliced them???
|
afi360
R/T
2/04/2003
01:06:03
|  RE: tb swap and coil location
IP: Logged
Message:
i just switched out my factory coil for a blaster ss this weekend. i relocated the coil to the battery tray (i have an optima, so i have extra room, you may need to mount elsewhere)..the green w/ orange stripe is positive, the black with gray stripe is negative...this is on a 99 r/t yours may vary.
|
Andy
Dodge Dakota
JOIN HERE
2/04/2003
02:29:57
| RE: tb swap and coil location
IP: Logged
Message:
Don't install a new throttle cable, just switch the linkages of the TBs. Much easier and cheaper.
|
mtlcafan79
GenIII
2/04/2003
14:10:13
| RE: tb swap and coil location
IP: Logged
Message:
I switched the cable on mine. I found it a lot easier to swap than what others have described.
Sean
|
DakotaDan
*GenIII*
2/04/2003
17:03:29
| RE: tb swap and coil location
IP: Logged
Message:
Dread You've Got Mail !!!!!!!
Dan
Next Time You Think You're Perfect
~~~~~Try Walking On Water~~~~~
|
no-neck
Dodge Dakota
JOIN HERE
2/04/2003
17:06:19
| RE: tb swap and coil location
IP: Logged
Message:
Dread,
I swapped mine in under ten minutes, literally. After you undo the cable from the gas pedal, tie a sturdy piece of string or twine around it and then pull the cable out from the engine side. I had no problem popping the old one out and using the string to feed the new one back through. Then you just get you hands down on the clip and push like an SOB. It snaps into place and your done. I'm a big guy with big hands and if I can get my hands down in there to pop the fitting in then anybody can. Just my 2 cents.
|
1Flamed92Dak
GenII
2/05/2003
00:25:31
| RE: tb swap and coil location
IP: Logged
Message:
Well im not a GenIII but the MSD hooks up the same way Green with Orange stripe is correct.  
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
