| From | Message |
chad
Dodge Dakota
JOIN HERE
7/27/2002
13:23:51
|
 Subject: TPS question
IP: Logged
Message:
I just tested the TPS with a volt meter and it read 5.1v. After reading speedtweaks it says it should be close to .7v. I disconnect the TPS and put the neg. side in the middle terminal and grounded it to the battery.now my check engine light is on so i have to reset my computer. any help is appreciated.thanks
-chad-
|
HSKR
Dodge Dakota
JOIN HERE
7/27/2002
14:41:12
|  RE: TPS question
IP: Logged
Message:
How were you checking the TPS voltage?? Shoudl be done with key on/engine off. black probe to ground and red probe on orange wire with the connector on the sensor. Shouldn't read more than .75vdc at idle(no moving of the linkage)
|
chad
Dodge Dakota
JOIN HERE
7/28/2002
01:20:33
| RE: TPS question
IP: Logged
Message:
i figured it out..im a moron.but thanks for the help.
-chad-
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
