| From | Message |
Boomer
Dodge Dakota
JOIN HERE
6/29/2002
00:16:20
|
 Subject: Brend...Mopar Computer
IP: Logged
Message:
Just got my Mopar PCM for my truck in. The engine starts fine and I tried a small rev, and it seemed fine as well. But, I don't have any dash items. They come off their 'ignition off' mode, but only a couple of millimeters, never to the actual reading. Basically, no tach, no trip odometer, no oil press, etc. The odometer flashes, and because of the above, I didn't do a road test.
1997, 5.2, 4x4, auto.
Bernd,
I'm also awaiting the fastman throttle body and the R/T cam and lifters.
Everything that came in so far has been the PCM, K&N, rockers (guide plates & lifters), water pump, and thermostat. Just thought I'd put that across since most of it came in earlier this week.
Can't wait to put my goodies on :)
Thanks a lot
Boomer
(J.L. in Jersey)
|
bernd
*GenIII*
 
7/01/2002
08:12:32
| RE: Brend...Mopar Computer
IP: Logged
Message:
Sorry for the late response...been out of town on a family emergency.
I'll check into this later on this AM (i'm back at the shop today).
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
Boomer
Dodge Dakota
JOIN HERE
7/02/2002
00:42:04
| RE: Brend...Mopar Computer
IP: Logged
Message:
Hope all is well at home, no problems, the truck is just awaiting a few things. No hurry. Sorry about the typo in the original post. Anyway, the K&N is in and is running good, just need to get rid of the paper weight under the TB. Hopefully I have new project of a childhood dream to work on here soon.
Boomer
|
Bernd
*GenIII*
7/02/2002
08:28:59
| RE: Brend...Mopar Computer
IP: Logged
Message:
I'm back in TX now. I've called the warehouse to find out the status of the cam/lifters and also with Fastman on the TB.
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
Boomer
Dodge Dakota
JOIN HERE
7/02/2002
11:38:46
| RE: Brend...Mopar Computer
IP: Logged
Message:
Appreciate that......
One last question about the computer (Mopar PCM). I disconnected the battery, pulled out the old, inserted the new. Reconnected the battery, and then turned the ignition on. The gagues came up from their 'off' mode, but that was it. The truck starts fine, but I didn't drive it because of the gagues (no tach, batt, oil, etc) and the odometer was flashing the current milage.
What should I do, or is it a bad PCM?
Boomer
|
Bernd
*GenIII*
7/02/2002
22:06:53
| RE: Brend...Mopar Computer
IP: Logged
Message:
If there's a dealer close by...have them flash the VIN into the PCM. This will also tell you if it's bad or not.
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
Boomer
Dodge Dakota
JOIN HERE
7/03/2002
01:59:38
| Bernd...got it right this time...
IP: Logged
Message:
Cool, if it is bad, do I send it back to you, or do I have them replace it?
Boomer
|
Bernd
*GenIII*
7/03/2002
08:38:15
| RE: Brend...Mopar Computer
IP: Logged
Message:
If it's bad...i'll handle it.
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
Boomer
Dodge Dakota
JOIN HERE
7/04/2002
01:29:34
| RE: Brend...Mopar Computer
IP: Logged
Message:
Roger!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
