| From | Message |
Crusty
Dodge Dakota
12/14/2001
17:48:25
|
 Subject: Custom Intake is IN!!
IP: Logged
Message:
So i put on my "Bakerman" intake today and this thing rips. With the flowmaster and intake it roars. really opened up the motor. I recommend it to anyone, cost me $64 including K&N filter. Now for the PCM...
|
BMAC
Dodge Dakota
12/17/2001
09:46:01
| RE: Custom Intake is IN!!
IP: Logged
Message:
OK, where did you get it?
I want one.
|
Crusty
Dodge Dakota
12/17/2001
11:33:14
| RE: Custom Intake is IN!!
IP: Logged
Message:
2 Fernco 90 degree rubber plumbing deals
10 inch piece of 3 inch ABS
3 inch piece of 3 inch ABS
1 K&N Airfilter part no. RC-2530
www.martelbros.com for the filter
The rest your local hardware store..
When putting this together put the ABS in the freezer for like 20 min and everything will slide in nicely. Oh and the filter opening will fit over the ABS tube. All together $64 including filter, yours will be less by about $10 since I got ripped by my hardware store for the Ferncos.
|
Fillupd
Dodge Dakota
12/17/2001
17:26:04
| RE: Custom Intake is IN!!
IP: Logged
Message:
I did the bakerman type setup and used a RC-2530 filter also, although I liked the stud sticking out the front of the filter for mounting, I think I would opt for a bigger inlet to make the connection to the ABS easier. I ended up taking a router to the end of the ABS piece that clamps inside the filter to make it fit. I made a bracket and bolted it to the end of the filter and to the fender well close to the front where the rubber flap used to be. The bends are called Fernco 3" Quickie Bends.
|
Fillupd
Dodge Dakota
12/17/2001
17:29:14
| RE: Custom Intake is IN!!
IP: Logged
Message:
http://www.dodgedakota.net/boards/per/2501.html
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
