Forums
Forum Tools
|
 |
03:28:49 - 04/24/2024
Dakota Performance
| From | Message |
EMTSquad51
Dodge Dakota
JOIN HERE
9/14/2005
00:44:16
|
 Subject: Dynomax Ultaflow
IP: Logged
Message:
I know this subject has been beat to death already on here, but here goes anyway. I just had a DynoMax Ultraflow SS on my '00 Dak QC 4.7. Kept stock pipes and just cut out the factory muffler, cut an extension pipe and clamped in the Dynomax muffler. I'll tell you, regardless of everything I read on here about it (for the most part) I LOVE this muffler! Has a nice tone to it at idle and up to around 3300 rpms. Nice and loud when you punch it, didn't lose ANY low end (gained a little top end actually), and when driving down the road or highway, rolled up the windows, turned off the stereo, and could BARELY notice any difference from the stock muffler (which is why I didn't go with the flowmaster 40 series) No offense to anyone that has one, but I rode in a dak with same setup as mine with the flowmaster, and there was just a LITTLE too much drone in the cab considering I drive the truck about 4-500 miles a week. Anyway, just my 2 cents. LATER!
|
prple-gaseatr
Dodge Dakota
JOIN HERE
9/14/2005
16:59:23
|  RE: Dynomax Ultaflow
IP: Logged
Message:
its wat i got on my 99 r/t too,..its nice
|
EMTSquad51
Dodge Dakota
JOIN HERE
9/15/2005
15:06:01
| RE: Dynomax Ultaflow
IP: Logged
Message:
prple, did you see any increase in mpg at all? I haven't been able to tell yet... still have that "new sound" right foot. Just can't seem to get my foot to NOT press all the way down at about every stop yet! hehe
|
Riv
Dodge Dakota
JOIN HERE
9/16/2005
23:36:25
| RE: Dynomax Ultaflow
IP: Logged
Message:
I just finished my exhaust on my 00 R/T,and damn man does it sound awesome. PPH headers, 3" high flow cat, 3" stainless pipe to 3" Dynomax ultraflow, out the stock tailpipe(cutwhere it expands to 3").
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
