Beerhat
Dodge Dakota
JOIN HERE
5/29/2021
19:34:04
|
 Subject: Torsion bar crank, height
IP: Logged
Message:
2003 4.7 4x4 Quad
Hey guys, so I just mounted up some BFG KO2's in 265/75/16's (31.6 dia), and have cranked my torsion bars a bit to clear some minor fender rubbing. Pretty sure they were sagging before, so not really sure where the stock height really was to begin with.
Top of fender is still an inch lower than the rear. So, still slightly raked and not exactly 'level'. The height is fine for me and helped with the clearance, but I'm curious if the front axle/cv angles are still within normal tolerances. Really don't wanna lunch my cv's.
I'm about an inch off the front bumpstops. FWIW.
What's the stock difference in rear height, 2 inches?
Truck suspension is stock, other than Bilsteins shocks, which probably add 1/4" of height.
Thanks!
Dan
|
