Forums
Forum Tools
|
 |
03:13:34 - 05/02/2024
Off Road
| From | Message |
Catfish Craig
Dodge Dakota
JOIN HERE
2/05/2006
14:30:30
|
 Subject: Anyone that Has Removed Half-Shafts
IP: Logged
Message:
Anyone else had this trouble? I'm in the middle of the front 4.56 swap and cant get the driver side half-shaft off. I pulled the bearing nut and removed the whole driver’s side axle with the differential. I put a lot of PB on, but was still unable to get the shaft off the axle. I know I can just put it back together this way, but i was going to check the spines. Any Ideas?
2002 QC AWD 4.7 3" PA SC K&N FIPK 285/75/16 Mud
CC
|
jayb
Dodge Dakota
JOIN HERE
2/05/2006
21:22:22
|  RE: Anyone that Has Removed Half-Shafts
IP: Logged
Message:
i know what its like to remove cv axles from alot of 4x4's, but not a genIII dakota. on my gen 2, you just gotta move it around and find out the best way to do it. otherwise, you might have to unbolt a ball joint.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
