Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
23:26:29 - 04/19/2024

Off Road
FromMessage
bad dakota
Dodge Dakota
JOIN HERE
 Email

6/26/2004
00:49:17

Subject: TSL Radials: 32x10.50 or 33x12.50
IP: Logged

Message:
i was wondering if i could put some 33x12.50 super swamper TSL radial's on 15x8 pro comp wheels (same backspacing as the AE589's) without triming a whole lot, if not i am going with the 32x10.50's. I want the 33's cause of the 12.50 part too cause i want wider tires than the 10.50's. so please help me on this cause i am ordering everything some time this week. thanks

Oh, by the way i have a 98 4x4 sport



bad dakota
Dodge Dakota
JOIN HERE
 Email

6/27/2004
23:54:53

RE: TSL Radials: 32x10.50 or 33x12.50
IP: Logged

Message:
ANYONE????????



conig
Dodge Dakota
JOIN HERE
 Email

6/28/2004
10:16:22

RE: TSL Radials: 32x10.50 or 33x12.50
IP: Logged

Message:
I don't think you will be able to run 33-12.50 without trimming. the back spacing pushes the wheels out a good bit. Also if you look at the actual specs of tires on superswampers wedsite the tire is usually bigger then other tire makers in the same size.



bad dakota
Dodge Dakota
JOIN HERE
 Email

6/28/2004
11:34:15

RE: TSL Radials: 32x10.50 or 33x12.50
IP: Logged

Message:
i know i will have to trim some, but i was wondering where at, and will i have to trim sheet metal, cause if i have to trim sheet metal then i will probably go with the 32's. and i also know that the tires are about the size if not a little bigger than listed.



conig
Dodge Dakota
JOIN HERE
 Email

6/28/2004
17:06:54

RE: TSL Radials: 32x10.50 or 33x12.50
IP: Logged

Message:
correct swamper is eiither the size listed or a tad bigger. unlike procomp my exterrians are 31-12.50 on the sidewall but are listed as 30.2-12.80 on procomps website. they do look bigger then 30's but whatever.

I would think just the inner fender lining and probable on the plastic bumper valance.

do you have fender flares? I ask because at first I didn't need to trim mine but when I went to a 2inch lift (2wd) I did but not anywere thats noticible. I did angle grind some metal and bend the appropriate pices of metal to get a no scrib situation on mine. honestly unless I told you or you had a photographic memory. I doubt you would know. I covered everything in sound deadening under body spray after words.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.