Forums
Forum Tools
|
 |
02:53:30 - 04/23/2024
Off Road
| From | Message |
MD
Dodge Dakota
JOIN HERE
3/08/2003
00:27:45
|
 Subject: Polyurethane Bushings Question
IP: Logged
Message:
I have a 2000, 2wd, 4.7, SLT DAK with handling pkg. I want to install a set of Energy front sway bar bushings. But, they list 2 sizes for the DAK - a 28mm and a 30mm.
Does anyone out there know what came standard on this vehicle? Anyone familiar with this upgrade - is it worthwhile?
Thanks,
MD
|
2THEXTRM
GenIII
3/08/2003
07:33:09
|  RE: Polyurethane Bushings Question
IP: Logged
Message:
I was wondering nearly the same thing for my 01 4x4 if anyone has found ANY poly bushings that fit. I would really like a full poly replacement kit(body, sway, ifs, etc.) but that may happen in ten years:)
Flowmaster cat back, Volant Intake, Poweraid TB Spacer, Splitfire Plugs, full synthetic fluids
3 inch body/3 inch Block Lift, 315 70-17 on AE 251's, Rancho 9000x's
Grizzly double/single rollbar with (6) Hella's, Manik Nerfs/Tailight Guards, Line-X, Hard Work & $$$$$$$$$$ Rancho lift ordered!!!
|
rockgod
Dodge Dakota
JOIN HERE
3/10/2003
21:25:09
| RE: Polyurethane Bushings Question
IP: Logged
Message:
I redid the entire suspension front and rear with PST graphite impregnated poly bushings on my El Camino and now they are squeaking badly on cold mornings going over traffic calming humps and the like. They did improve handling but ride a little more harshly. It was also a miserable 2 week job in the street if front of the house.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
