| From | Message |
COREY COOPER
Dodge Dakota
JOIN HERE
11/22/2002
20:49:51
|
 Subject: LIFT
IP: Logged
Message:
cAN ANYONE TELL ME HOW TO LIFT A 2000 DAKOTA WITH THE TORSION BARS. IF SO HOW HIGH CAN YOU GO AND DOES IT AFFECT ANYTHING ELESE.I HEARED YOU CAN PUT A 1" BLOCK IN THE BACK AND CRANK THE TORSION BARS IN THE FRONT FOR A 3" LIFT. ANYTHING WILL HELP.
|
scott
Dodge Dakota
JOIN HERE
11/24/2002
09:25:33
| RE: LIFT
IP: Logged
Message:
i have a 2000 dakota and i cranked the torsion bars about 1.75" and that was all the shop recomended and i didnt put blocks in the back (basically makes the truck look even). i also put on 32x11.5 bfgoodrich ats and they dont rub. i just got done putting on a 3" body lift and the dakota looks sweet! as far as doing the torsion bars yourself...measure both sides of the truck up front from ground to frame. jack up the front of the truck so the front tires are off the ground (this will make it easier to adjust the bolts) and then just crank on the torsion bar bolts...an air wrench is nice to have for this. make sure to measure the frame to the ground when you are done to make sure the measurments are the same.
|
corey
Dodge Dakota
JOIN HERE
11/24/2002
18:42:26
| RE: LIFT
IP: Logged
Message:
Thank you for your info that will help me out alot.I'll try it.
|
Corey
Dodge Dakota
JOIN HERE
11/24/2002
18:46:20
| RE: LIFT
IP: Logged
Message:
Thank you for your info that will help me out alot.I'll try it.let me know how the body lift goes thats what i want to do next.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
