| From | Message |
SHAGGYFROG
Dodge Dakota
JOIN HERE
4/25/2002
14:12:25
|
 Subject: HOW DO I WIRE A MONO AMP TO A T-FORM
IP: Logged
Message:
I BOUGHT A SONY XM-1600(MONO AMP). IT HAS TWO SETS OF SPEAKER OUTS BUT THE T-FORM ONLY HAS ONE SET OF INPUTS. THE SONY MANUAL SAYS IF YOU ARE PUSHING 1 SUB TO WIRE IT TO THE LEFT OUTPUT, IF TWO SUBS, WIRE THEM SEPERATLY TO EACH OUTPUT. BUT WITH THE T-FORM I AM GOING TO PUSH TWO SUBS WITH ONE SPEAKER WIRE. THE SONY MANUAL SAYS NOTHING ABOUT BRIDGING THE TWO OUTPUTS. HOW DO I WIRE UP FOR THE MOST (AND SAFEST) POWER? CAN I BRIDGE THE TWO OUTPUTS WITHOUT DAMAGE TO THE AMP? I HOPE THIS IS NOT TO CONFUSING. THANKS FOR ANY HELP YOU CAN GIVE ME. I PUT THIS ON CUSTOM AUDIO ALSO BUT IT SEEMS MORE PEOPLE GO TO THE GENERAL BOARD.
|
R/Truck
Dodge Dakota
JOIN HERE
4/25/2002
14:19:48
|  RE: HOW DO I WIRE A MONO AMP TO A T-FORM
IP: Logged
Message:
Shaggy-
Keep it in the audio section.
BTW- You can't bridge a mono amp, just hook - to - and + to +. If you have two speakers hook one up to each set of outputs on your amp. But in the case of the thunderform just use one set.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
