Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
13:05:04 - 04/26/2024

General Dakota Board
FromMessage
Brandi
Dodge Dakota


10/25/2001
02:46:20

Subject: Help a Lady?
IP: Logged

Message:
I have a 93 Dakota that will not start. It won't even crank over. I replaced the battery, still nothing. So I figure it is either my starter or the solinoid. I can't find the Solinoid anywhere. Can someone please help me? Where is that pesky Solinoid.



DAK2
Gen III
 Email User Profile


10/25/2001
08:19:27

RE: Help a Lady?
IP: Logged

Message:
Brandi,
The solenoid is located on the starter.Hope this helps

Y2K DAK 3.9L 5 Spd OS/2 Keeps going&going&going

Clevite 77
Dodge Dakota


10/25/2001
09:08:25

RE: Help a Lady?
IP: Logged

Message:
Do your headlights work? if so I'd say starter, if they are dim i would check the negative wire to the block, could be loose or corroded



CW
Dodge Dakota
 Email

10/25/2001
09:28:15

RE: Help a Lady?
IP: Logged

Message:
If all you hear is a single click then it is proabably the contacts in the starter. They are replaceable with a little mecanical knowalge. If you do not hear any click at all check the fuses in the dash and under the hood the could be one burnt and not sending power to the solenoid on the starter. Have seen bad battery cables on vehicles of that age as well.



Brandi
Dodge Dakota


10/25/2001
10:14:49

RE: Help a Lady?
IP: Logged

Message:
Thanks Guys. I will check the starter. I do hear a single click comming from the area of the starter, but it won't turn. my lights are bright.
Can I buy just a brush kit for the starter, or do I have to by the whole starter?



CW
Dodge Dakota
 Email

10/25/2001
14:17:30

RE: Help a Lady?
IP: Logged

Message:
You need a starter contact set not a brush kit. If you can find some one to supply you with the set all you have to do is remove the starter and you will see the solinoid on the top side of the starter remove the three screws holding the cover on and there will be a piston with a spring pull it out and you will see the contacts right there replace them and you will be on your way. I do this all the time for customers and I charge aout a hour and a half depending on vehicle.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.