| From | Message |
pro23
Dodge Dakota
JOIN HERE
4/12/2005
18:49:05
|
 Subject: S-BOLT
IP: Logged
Message:
Hi everyone, I know the dimensions and all for the s-bolt, its just that I dont know how to make the bend in the middle for the s-bolt. for those of you that have made the s-bolt, what tool did you use to bend the middle?
|
Brandon
Dodge Dakota
JOIN HERE
4/12/2005
19:42:17
|  RE: S-BOLT
IP: Logged
Message:
Is the S Bolt for a air cleaner intake?
|
athenianR/T
Dodge Dakota
JOIN HERE
4/12/2005
20:51:23
|  RE: S-BOLT
IP: Logged
Message:
yeah, its for the stock intake, try to use two box end wrenches to bend it, or you can use a tube bender. a last ditch would be to lay it on a hard surface, then hit it with a hammer til its bent... but the closed ended wrench trick should work.
|
NOFORDS
Dodge Dakota
JOIN HERE
4/13/2005
01:52:44
| RE: S-BOLT
IP: Logged
Message:
just slap it into a vise and heat it up with a torch....get it red and grab it with a good pair of pliers...once its hot it will be like butter to bend
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
