Forums
Forum Tools
|
 |
20:29:20 - 04/25/2024
General Dakota Board
| From | Message |
4x4x4dr
GenIII
 
9/18/2004
09:41:00
|
 Subject: 45RFE tranny pan torque specs
IP: Logged
Message:
I have the 45RFE tranny on a 2000 4x4. I'm going to be changing the tranny fluid later today and need to know the torque specs for the tranny pan bolts. I fairly sure those are the only bolts involved. I've searched high and low through several threads and have come up empty. All I could find was drain and fill plug torque specs and those don't help. If anyone knows, thanks ahead of time.
~Tracy
'00 4x4 SLT QC 4.7 Auto Mods:My Dak
|
specs
Dodge Dakota
JOIN HERE
9/18/2004
12:44:37
|  RE: 45RFE tranny pan torque specs
IP: Logged
Message:
from 2003 service manual,same trans.
screw to hold filter to valve body 40 inch #s
cooler return filter(tiny oil filter) 125 inch #s
bolts to trans pan 105 inch #s
also says to replace new primary oil filter seal in the oil pump inlet bore(for the neck of the flat filter). says to put seal in first and seat with butt end of hammer or simular tool. do not install with seal on filter as an assembly,damage to trans will result(i just left the old one in,will change next time). i used permatex right stuff for pan gasket.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
