| From | Message |
LyleB
Dodge Dakota
JOIN HERE
4/21/2004
14:19:11
|
 Subject: grease zerks
IP: Logged
Message:
I was going to lube the chassis on my 2000 Dakota Club cab 3.9L but when I crawled underneath, there were no grease zerks. An after market manual I bought says that if there are no zerks, to install some. Is there a plug or something where these would install? If so, is it obvious? I'm no master mechanic, but just looking, I couldn't figure out where they'd go even if I had them. Any advice appreciated.
|
360
Dodge Dakota
JOIN HERE
4/21/2004
17:07:52
| RE: grease zerks
IP: Logged
Message:
no way to grease these Daks... thats one reason most of us have to replace the ball joints all the time..terrible design on Chrysler's part
|
nwf_snake
Dodge Dakota
JOIN HERE
4/22/2004
08:18:24
| RE: grease zerks
IP: Logged
Message:
You can use a needle attachment to your grease gun and slip it under/puncture the rubber boot. If you wait too long to do this, then you will end up replacing them!
|
not really
Dodge Dakota
JOIN HERE
4/22/2004
17:36:56
| RE: grease zerks
IP: Logged
Message:
all it does is grease the boot non of it gets in between the ball and socket where it is needed.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
