Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
02:25:02 - 04/26/2024

General Dakota Board
FromMessage
bakindak
Dodge Dakota
JOIN HERE
 Email

1/23/2004
21:28:24

Subject: Caliper Pin issue
IP: Logged

Message:
One of the holes in my mounting bracket for my caliper pins is too large. The person who owned the truck before me broke a pin and then drilled and tapped the hole and put a helie coil in there and I accidentally removed it not realizing what it is. Is there a suitable replacement that I can use in place of the caliper pin that will fit the hone



devious
Dodge Dakota
JOIN HERE
 Email

1/23/2004
21:56:06

RE: Caliper Pin issue
IP: Logged

Message:
I just had the same issue this weekend. The treads for the original pin were stripped. I should have just retreaded the hole but i drilled it out, treaded and replaced it with a thicker cast hardened bolt. Got the bolts from a hardware store. They have to be cast hardened. The bolt was to long and not as thick as the regular bolt. So then i had to cut it so it didn't hit the brake pad. The caliper still had a rattle everytime i hit a bump. I then had to put a rubber sleeve on the bolt to stop the rattle. Man i hope this help because i was lost for about a week trying to figure this out. It might take a couple of trips to the hardware store. Get the tap and the screw at the same time and measure the length of the bolt from where the treads stop. compare it to the factory bolt.



whatever
Dodge Dakota
JOIN HERE


1/24/2004
06:59:34

RE: Caliper Pin issue
IP: Logged

Message:
put in another heli coil from autozone or wherever - dah
it ain't rocket science.



slopehead
Dodge Dakota
JOIN HERE


1/24/2004
07:21:29

RE: Caliper Pin issue
IP: Logged

Message:
the way whatever said to fix it is correct the way devious said could get you killed.



jmagsho
Dodge Dakota
JOIN HERE


1/25/2004
10:46:24

RE: Caliper Pin issue
IP: Logged

Message:
Either replace the heli-coil, or bite the bullet and replace the spindle.



Jeff G
Dodge Dakota
JOIN HERE


1/26/2004
14:16:59

RE: Caliper Pin issue
IP: Logged

Message:
Please, for safety's sake, replace the spindle. Brakes are not something you want to screw with. It's not just your life in danger.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.