Forums
Forum Tools
|
 |
14:32:29 - 04/26/2024
General Dakota Board
| From | Message |
BDak
Dodge Dakota
JOIN HERE
1/13/2004
09:41:34
|
 Subject: Wiper Motor
IP: Logged
Message:
2000 CLub Cab, unfortunately the 3.9L
My wiper motor has developed a hum/noise when used at higher wiper speeds. The motor has already been replaced once (about 2 months after purchased brand new). Is this problem common with the Dakota, I saw very little in the archives on the subject. If anyone has replaced their motor, how difficult was the replacement, and how pricey the motor? Right now I just plan to drive on until the S.O.B. stops working. Thanks in advance-
|
EBL
Dodge Dakota
JOIN HERE
1/13/2004
12:08:39
|  RE: Wiper Motor
IP: Logged
Message:
The Gen II (Probably the same motors) are held on with 3 nits. The bolts are attached to the truck.
It is an easy job to pull the motor. When you do, check the condition of the plastic grommits in the assembly. The weather does horrible things to them.
They are cheap, but you have to buy them from the dealer.
Be careful waiting for a wiper motor to break before replacing it. They tend to go bad when you need them the most.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
