Subject: Powsr issues. |
1999 DODGE DAKOTA 4X4
My problem is like this
Sony cd deck.
All wires connected right.
Kicker Amp going to 1 10 inch kicker sud woofer.
Sometimes when I turn the unit on it says failure on the
readout. Will still play. Sony says that when failure comes up
its a speaker wiring issue. Can adjust left to right front to rear
and it goes where it should.
Ok now when I turn the sound up it will shut down.
Sometimes at level 30 or as low as 18. Sometimes the unit
won't come on at all. When it doesn't come on at all I can turn
the ignition off and then my blinker fuse will start clicking. Like
if I had my blinker on.
When I first bought the truck it seemed to work fine.
It slowly got worse and worse.
Battery has been replaced. Voltage to the battery is in spec..
What would cause the clicking in the flasher (blinker) fuse
when the ignition is turned off?
Could this also just be a bad amp output from my alternator?
Thanks in advance.
| RE: Powsr issues. |
I think you need to put in a power cap.
They come in many different sizes, and
are rated in ferrets. A 5 ferret is lower
than30 ferrits.Short story they are power
holders like a spare batt. My batt started
blinking thenadded power cap end of
| || P 1|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages