| From | Message |
dakslt
Dodge Dakota
JOIN HERE
12/29/2002
18:07:36
|
 Subject: will this amp work?
IP: Logged
Message:
i just bought a thunderform will the 6000's in it. I have a Jensen 600 watt 4 channel bridgeable amp as well. Will this amp work with the subs? Any info would be greatly appreciated. Thanks.
|
Joe
Dodge Dakota
JOIN HERE
12/29/2002
19:51:58
| RE: will this amp work?
IP: Logged
Message:
Yes it should work fine , Brigde the front and rear channels , Use the front channel for 1 sub and the rear for the other
|
holtsch
Dodge Dakota
JOIN HERE
12/30/2002
02:12:11
| RE: will this amp work?
IP: Logged
Message:
i'm not familiar w/the amp but you might want to make sure the impediance is correct
|
lowdaksport
Dodge Dakota
JOIN HERE
12/30/2002
10:43:47
| RE: will this amp work?
IP: Logged
Message:
i had an older jensen for while and it wasn't bridgeable and some ohm and i can reamember. but my sub was the ohms it wouldn't do. anyways a few months later it got really hot and kicked its own a$$
|
dakslt
Dodge Dakota
JOIN HERE
12/30/2002
17:44:47
| RE: will this amp work?
IP: Logged
Message:
thanks for almost making sense there lowdaksport
jk
|
holtsch
Dodge Dakota
JOIN HERE
12/31/2002
02:20:51
| RE: will this amp work?
IP: Logged
Message:
what ohms are your subs? svc or dvc? at what ohm does your amp put out the most power? answer these and i'll tell you if your amp will work
|
dakslt
Dodge Dakota
JOIN HERE
1/01/2003
12:19:54
| RE: will this amp work?
IP: Logged
Message:
this is the info for the amp:
http://www.jensen.com/mobile/prod_mobile_no.asp?product=130
thanks for any help you can give
|
92Dakota
Dodge Dakota
JOIN HERE
1/01/2003
21:36:24
| RE: will this amp work?
IP: Logged
Message:
DaksIt
That amp will work just fine.
Bridge the front and rear channels. This means take the left and right outputs for the FRONT side of the amp. Take the positive from the left channel and the negative from the right channel. Run these wires to one of the MTX subs. This will successfully bridge your front section of the amp at 4 ohms giving you 200 watts RMS.
Do the same for the REAR section of the amp.
It should sound pretty good. Good luck
|
holtsch
Dodge Dakota
JOIN HERE
1/02/2003
11:38:49
| RE: will this amp work?
IP: Logged
Message:
dakslt
that amp will work as long as your sub(s) will match up to it. I take it those subs are svc? As long as their svc and 4 ohm subs your fine
|
dakslt
Dodge Dakota
JOIN HERE
1/02/2003
17:35:29
| RE: will this amp work?
IP: Logged
Message:
thank you so much for all the help. i really appreciate it.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
