| From | Message |
jason
Dodge Dakota
JOIN HERE
6/04/2003
22:36:38
|
 Subject: Torque on Ball Joint to A-Arm?
IP: Logged
Message:
I am in the middle of lifting my 97 dakota with a 3" FabTech liftkit. However, FabTech doesn't give any specs for how tight to torque down the four bolts that hold the ball joint to the upper a-arm. What should I use? While we're at it, I replaced the lower a-arms ball joints and can't find any torque settings for how tight to tighten the new one to the a-arms. Thanks for any/all info.
|
thats_it
Dodge Dakota
JOIN HERE
6/05/2003
08:45:16
| RE: Torque on Ball Joint to A-Arm?
IP: Logged
Message:
Put the box-end on it, and pull medium hard when
it tightens up.. That should be about right.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
